Flow Switch 6560-852

For most LED 120/240v convertible systems.  

OEM flow switch on the following models.

Jacuzzi

Sundance

Please note, two new 6540-262 will be required for installation. Click here to order.

Pro Tip:  Before you replace your flow switch, make sure you have proper water flow.  Make sure your pleated filter is clean and less than one year old.  For those using the ProClarity or MicroClean filter, make sure your filter is less than four months old, especially if you have hard water. 

If that checks out, please verify your circulation pump is in fact moving water properly.  If that checks out, you can test your old flow switch for continuity.  When the pump is operating, you should have zero resistance.  When the pump is not operating, depending on your meter, your meter should read open line. If you are receiving anything outside of those perameters, then its time to replace that switch.  If your switch is reading fine, then you likely have a circuit board issue.

Electronics Notice: Due to the delicate nature of electrical components, all sensors, circuit boards, control panels, transformers, pumps, and heaters are non-returnable items.